Reference Guide

Over 64B packets: 0 0
pps 0
Over 127B packets: 0 0
pps 0
Over 255B packets: 0 0
pps 0
Over 511B packets: 0 0
pps 0
Over 1023B packets: 0 0
pps 0
Error statistics:
00:04:36: %RPM0-P:CP %CHMGR-5-PEM_INSERTED: Power entry module 3 of unit
0 is inserted
Input underruns: 0 0
pps 0
Input giants: 0 0
pps 0
00:04:36: %RPM0-P:CP %CHMGR-0-PS_UP: Power supply 3 in unit 0 is up
Input throttles: 0 0
pps 0
Input CRC: 0 0
pps 0
Input IP checksum: 0 0
pps 0
Input overrun: 0 0
pps 0
Output underruns: 0 0
pps 0
Output throttles: 0 0
pps 0
m - Change mode c - Clear screen
l - Page up a - Page down
T - Increase refresh interval t - Decrease refresh
interval
q - Quit
mtu
Set the link maximum transmission unit (MTU) (frame size) for an Ethernet interface.
Z9500
Syntax
mtu value
To return to the default MTU value, use the no mtu command.
Parameters
value Enter a maximum frame size in bytes. The range is from 592 to 9216. The default is
9216.
Defaults 9216
Command Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
Interfaces 641