Reference Guide
Version Description
6.1.1.0 Introduced on the E-Series.
Usage
Information
When you configure keepalive, the system sends a self-addressed packet out of the configured
interface to verify that the far end of a WAN link is up. When you configure no keepalive, the system
does not send keepalive packets and so the local end of a WAN link remains up even if the remote end is
down.
linecard portmode
Split a single 40G port into four 10G ports on the switch.
Z9500
Syntax
linecard slot-id port number portmode quad
Parameters
linecard
slot-id
Enter the slot ID of a Z9500 line card to reset. The range of slot IDs is from 0 to 2.
number
Enter the port number of the 40G port to be split. A 40G port number is a multiple
of 4; for example, 0, 4, 8, 12, ... 120, 124, 128).
Defaults Disabled.
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Dynamically fan-out feature is added.
9.2(1.0) Introduced on the Z9500.
Usage
Information
Enabling quad mode on a port removes the interface configurations (if any) on the port after a save and
reload. Be sure that the port is removed from other L2 and L3 feature configurations.
You can dynamically fan-out the 40G to 4x10G and vice versa without reload.
This command cannot be used if LR4 optics are inserted in the 40G port.
monitor interface
Monitor counters on a single interface or all interfaces on a line card. The screen is refreshed every five seconds and the CLI
prompt disappears.
Z9500
Syntax
monitor interface [interface] [linecard slot-id]
To disable monitoring and return to the CLI prompt, press the q key.
Parameters
interface
(OPTIONAL) Enter the following keywords and slot/port or number information:
● For the management port, enter the keyword managementethernet then
the slot (0 or 1) and the port (0).
Interfaces 637










