Reference Guide

Command Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S4810, S4820T, S6000 and Z-Series.
ip dhcp snooping verify mac-address
Validate a DHCP packet’s source hardware address against the client hardware address field (CHADDR) in the payload.
Z9500
Syntax
[no] ip dhcp snooping verify mac-address
Defaults Disabled
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.3.1.0 Introduced on the E-Series.
7.2.1.0 Introduced on the C-Series and S-Series.
ipv6 dhcp snooping verify mac-address
Configure to enable verify source mac-address against ipv6 DHCP packet mac address.
Syntax
[no] ipv6 dhcp snooping verify mac-address
To disable verify source mac-address against ipv6 DHCP packet mac address, use the no ipv6 dhcp
snooping verify mac-address command.
Defaults Disabled
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S4810, S4820T, S6000 and Z-Series.
544 Dynamic Host Configuration Protocol (DHCP)