Reference Guide

Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Introduced on the C-Series and S-Series.
disable
Disable the DHCP server.
Z9500
Syntax
disable
DHCP Server is disabled by default. To enable the system to be a DHCP server, use the no disable
command.
Defaults Disabled
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Introduced on the C-Series and S-Series.
dns-server
Assign a DNS server to clients based on address pool.
Z9500
Syntax
dns-server address [address2...address8]
Parameters
address Enter a list of DNS servers that may service clients on the subnet. You may list up
to eight servers, in order of preference.
Defaults none
Command Modes DHCP <POOL>
Dynamic Host Configuration Protocol (DHCP) 523