Reference Guide

The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Added a warning message to the off-line diagnostic.
7.7.1.0 Introduced on the S-Series.
Usage
Information
To run diagnostic tests on an offline switch, use the diag command.
The system reboots when offline diagnostics complete. This reboot is an automatic process. A warning
message appears when the offline system command is implemented.
Warning - Diagnostic execution will cause system to reboot after completion
of diags.
Proceed with Offline-Diags [confirm yes/no]:y
Related
Commands
diag — run diagnostic tests on an offline switch.
online stack-unit— reload the system after running offline diagnostic tests.
online system
Reload a switch after running offline diagnostic tests.
Z9500
Syntax
online system
Defaults none
Command Modes EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.7.1.0 Introduced on the S-Series.
Usage
Information
This command is used to manually reset or reboot the system when diagnostics complete.
Related
Commands
diag — run diagnostic tests on an offline switch.
offline stack-unit— bring the system offline to run diagnostic tests.
Debugging and Diagnostics 485