Reference Guide

0 Input TLV pkts, 1 Output TLV pkts, 0 Error pkts,
0 Pause Tx pkts, 0 Pause Rx pkts
show interface pfc statistics
Displays counters for the PFC frames received and transmitted (by dot1p priority class) on an interface.
Syntax
show interface port-type slot/port pfc statistics
Parameters
port-type Enter the port type.
slot/port Enter the slot/port number.
Command Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS
Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the Z9500.
Example
(Summary)
Dell (conf-if-te-0/1)#show int te 0/1 pfc statistics
Interface TenGigabitEthernet 0/1
Priority Rx XOFF Frames Rx Total Frames Tx
Total Frames
--------------------------------------------------------------------------------------
-
0 0 0 0
1 0 0 0
2 0 0 0
3 0 0 0
4 0 0 0
5 0 0 0
6 0 0
0
7 0 0 0
ETS Commands
dcb-enable
Enable data center bridging.
Syntax
dcb enable[pfc-queues 1|4]
To disable DCB, use the no dcb enable command.
Parameters
pfc-queues Enter the pfc-queue range. To disable DCB, use the no dcb enable command. The
range is from 1 to 4.
Defaults The default is 2
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Data Center Bridging (DCB) 453