Reference Guide

Parameters
qos Optimize CAM usage for QoS.
Defaults Disabled.
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Introduced on the S-Series.
7.8.1.0 Introduced on the C-Series.
Usage
Information
When you enable this command, if a Policy Map containing classification rules (ACL and/or dscp/ ip-
precedence rules) is applied to more than one physical interface on the same port pipe, only a single copy
of the policy is written (only one FP entry is used).
NOTE: An ACL itself may still require more that a single FP entry, regardless of the number of
interfaces. For more information, refer to the “IP Access Control Lists”, “Prefix Lists”, and “Route-
map” sections in the Dell Networking OS Configuration Guide.
show cam-acl
Display the details of the CAM profiles on the chassis and all line cards.
Z9500
Syntax
show cam-acl
Defaults none
Command Modes EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Added support for nlbcluster show command output.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the C-Series.
Usage
Information
The display reflects the settings implemented with the cam-acl command.
Content Addressable Memory (CAM) 429