Reference Guide

match internal (OPTIONAL) Enter the keywords match internal to redistribute OSPFv3
internal routes only.
route-map map-
name
(OPTIONAL) Enter the keywords route-map followed by the name of an
established route map. Only the following ROUTE-MAP mode commands are
supported:
● match ipv6 address
● match ipv6 next-hop
● match ipv6 route-source
● set ipv6 next-hop
If you do not configure the route map, the default is deny (to drop all routes).
Defaults Not configured.
Command Modes ROUTER BGPV6-ADDRESS FAMILY
Command
History
Version Description
9.2(1.0) Introduced on the Z9500.
8.2.1.0 Introduced on the E-Series ExaScale.
7.4.1.0 Introduced
Usage
Information
When you enter the redistribute ospf process-id command without any other parameters, the
software redistributes all OSPF internal routes, external type 1 routes, and external type 2 routes.
router bgp
Enter ROUTER BGP mode to configure and enable BGP.
Z9500
Syntax
router bgp as-number
To disable BGP, use the no router bgp as-number command.
Parameters
process-id Enter the number of the OSPFv3 process. The range is 1 to 65535.
Defaults Not configured.
Command Modes CONFIGURATION
Command
History
Version Description
9.2(1.0) Introduced on the Z9500.
8.2.1.0 Introduced on the E-Series ExaScale.
7.4.1.0 Introduced
show capture bgp-pdu neighbor
Display BGP packet capture information for an IPv6 address.
Z9500
Syntax
show capture bgp-pdu neighbor ipv6-address
412 Border Gateway Protocol