Reference Guide

neighbor send-community
Send a COMMUNITY attribute to a BGP neighbor or peer group. A COMMUNITY attribute indicates that all routes with that
attribute belong to the same community grouping.
Z9500
Syntax
neighbor {ipv6-address | peer-group-name} send-community
To disable sending a COMMUNITY attribute, use the no neighbor {ipv6-address | peer-
group-name} send-community command.
Parameters
ipv6-address Enter the IPv6 address in the x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal fields of zeros.
peer-group-name Enter the name of the peer group to send a COMMUNITY attribute to all routers
within the peer group.
Defaults Not configured and COMMUNITY attributes are not sent to neighbors.
Command Modes ROUTER BGPV6-ADDRESS FAMILY
Command
History
Version Description
9.2(1.0) Introduced on the Z9500.
8.2.1.0 Introduced on the E-Series ExaScale.
7.4.1.0 Introduced
neighbor soft-reconfiguration inbound
Enable a BGP soft-reconfiguration and start storing updates for inbound IPv6 unicast routes.
Z9500
Syntax
neighbor {ipv4-address | ipv6-address | peer-group-name} soft-
reconfiguration inbound
Parameters
ipv4-address |
ipv6-address
Enter the IP address of the neighbor for which you want to start storing inbound
routing updates.
peer-group-name Enter the name of the peer group for which you want to start storing inbound
routing updates.
Defaults Disabled.
Command Modes ROUTER BGPv6 ADDRESS FAMILY (conf-router_bgpv6_af)
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
8.4.1.0 Added support for IPv4 multicast and IPv4 unicast address families.
8.3.19.0 Introduced on the S4820T.
Border Gateway Protocol 405