Reference Guide

Parameters
prefix-list name Enter the name of the prefix list.
NOTE: There is a 140-character limit for prefix list names.
Defaults none
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
9.0.0.0 Introduced on the Z9000.
8.3.19.0 Introduced on the S4820T.
8.3.10.0 Introduced on the S4810.
Related
Commands
show ipv6 prefix-list — View the selected IPv6 prefix-list.
maximum-paths
Configure the maximum number of parallel routes (multipath support) BGP supports.
Z9500
Syntax
maximum-paths {ebgp | ibgp} number
To return to the default values, use the no maximum-paths command.
Parameters
ebgp Enter the keyword ebgp to enable multipath support for External BGP routes.
ibgp Enter the keyword ibgp to enable multipath support for Internal BGP routes
number Enter a number as the maximum number of parallel paths. The range is 1 to 16. The
default is 1.
Defaults 1
Command Modes ROUTER BGPV6-ADDRESS FAMILY
Command
History
Version Description
9.2(1.0) Introduced on the Z9500.
8.2.1.0 Introduced on the E-Series ExaScale.
7.4.1.0 Introduced
Usage
Information
If you enable this command, use the clear ip bgp command to recompute the best path.
Border Gateway Protocol 393