Reference Guide

Version Description
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
7.6.1.0 Introduced on the E-Series.
MBGP Commands
Multiprotocol BGP (MBGP) is an enhanced BGP that enables multicast routing policy throughout the internet and connecting
multicast topologies between BGP and autonomous systems (ASs).
MBGP on the Dell Networking OS is implemented as per IETF RFC 1858.
BGPv4 is supported in the following:
Dell
Networking
OS Version
Platform Support
Z9500
7.8.1.0, MBGP
for IPv6
TeraScale and C-Series
7.8.1.0, MBGP
for IPv4
Multicast Only
S-Series
8.2.1.0, MBGP E-Series ExaScale
debug ip bgp dampening
View information on routes being dampened.
Z9500
Syntax
debug ip bgp [vrf vrf-name] [ipv4 {unicast | multicast} | ipv6 unicast]
dampening
To disable debugging, use the no debug ip bgp dampening command.
Parameters
vrf vrf-name Enter the keyword vrf followed by the name of the VRF to view information on
dampened routes corresponding to that VRF.
ipv4 multicast (OPTIONAL) Enter the keyword ipv4 followed by the keyword multicast to
view dampened-route information related only to ipv4 multicast routes.
ipv4 unicast (OPTIONAL) Enter the keyword ipv4 followed by the keyword multicast to
view dampened-route information related only to ipv4 unicast routes.
ipv6 unicast (OPTIONAL) Enter the keyword ipv4 followed by the keyword unicast to view
dampened-route information related only to ipv6 unicast routes.
Command Modes EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
356 Border Gateway Protocol