Reference Guide

Defaults Not configured
Command Modes CONFIGURATION-MAC ACCESS LIST-STANDARD
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
7.4.1.0 Added the monitor option.
6.1.1.0 Introduced on the E-Series.
Usage
Information
When you use the log option, the CP processor logs detail the packets that match. Depending on how
many packets match the log entry and at what rate, the CP may become busy as it has to log these
packet details.
By default, 10 ACL logs are generated if you do not specify the threshold explicitly. The default frequency
at which ACL logs are generated is five minutes. By default, flow-based monitoring is not enabled.
Use the monitor option only when you are using flow-based monitoring. For more information, refer to
the Port Monitoring chapter in the Z9500 Configuration Guide.
NOTE: When ACL logging and byte counters are configured simultaneously, byte counters may
display an incorrect value. Configure packet counters with logging instead.
Related
Commands
deny — configures a filter to drop packets.
permit — configures a filter to forward packets.
Extended MAC ACL Commands
When an access-list is created without any rule and then applied to an interface, ACL behavior reflects implicit permit. The
following commands configure Extended MAC ACLs.
The Z9500 supports both Ingress and Egress MAC ACLs.
NOTE:
For more information, also refer to the Commands Common to all ACL Types and Common MAC Access List
Commands sections.
deny
To drop packets that match the filter criteria, configure a filter.
Z9500
Syntax
deny {any | host mac-address | mac-source-address mac-source-address-mask}
{any | host mac-address | mac-destination-address mac-destination-address-
212 Access Control Lists (ACL)