Manualshelf

Reference Guide

ManualsBrandsDell ManualsComputer equipmentNetworking Z9500
1411141214131414141514161417141814191420
vlt-peer-lag port-channel
Associate the port channel to the corresponding port channel in the VLT peer for the VLT connection to an attached device.
Syntax
vlt-peer-lag port-channel id-number
Parameters
id-number
Enter the respective vlt port-channel number of the peer device. The range is from
1 to 512.
Defaults Not configured.
Command Modes INTERFACE PORT-CHANNEL
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.5(0.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
9.0.0.0 Introduced on the Z9000.
8.3.19.0 Introduced on the S4820T.
8.3.8.0 Introduced on the S4810.
9.2(0.0) Introduced on the M I/O Aggregator. This command is supported in Programmable-
Mux (PMUX) mode only.
1412 Virtual Link Trunking (VLT)