Reference Guide

upload trace-log
Upload a trace log file from a Z9500 CPU.
Z9500
Syntax
upload trace-log {rp | linecard slot-id} {cmd-history | hw-trace | sw-
trace}
Parameters
rp Enter the keyword rp to upload a trace log from the Route Processor CPU.
linecard slot-id Enter the linecard slot-id parameters to specify the line-card CPU whose
trace log you want to upload.
cmd-history Enter the keyword cmd-history to upload the command history from the
specified CPU.
hw-trace Enter the keyword hw-trace to upload the hardware trace log from the specified
CPU.
sw-trace Enter the keyword sw-trace to upload the software trace log from the specified
CPU.
Defaults None.
Command Modes CONFIGURATION
Command
History
Version Description
9.2(1.0) Introduced on the Z9500.
8.1.1.0 Introduced on the E-Series ExaScale.
7.5.1.0 Introduced on the C-Series.
Usage
Information
Trace log information is uploaded to flash:/TRACE_LOG_DIR.
util-threshold cpu
Configure the high or low CPU utilization thresholds for SNMP traps.
Z9500
Syntax
util—threshold cpu {5sec | 1min | 5min} {cp |rp | linecard slot–id | all}
{high {0-100} | low {0-100}}
Parameters
cpu-utilization-
time
Enter one of the following values to configure the threshold level for the time in
which a Z9500 CPU can be used:
● 5sec
● 1min
● 5min
cp Enter the keyword cp to configure the CPU utilization time for the Control
Processor CPU.
rp Enter the keyword rp to configure the CPU utilization time for the Route
Processor CPU.
140 Control and Monitoring