Reference Guide

Defaults If you do not configure a tunnel allow-remote address, all traffic destined to tunnel’s source address is
decapsulated.
Command Modes INTERFACE TUNNEL
Command
History
Version Description
9.5(0.1) Introduced on the Z9500.
9.4(0.0) Introduced on the S4810, S4820T, S6000 and Z9000.
9.3(0.1) Introduced on the S6000 and Z9000.
Usage
Information
You can configure up to eight allow-remote entries on a multipoint receive-only tunnel.
This command fails if the address family entered does not match the outer header address family of the
tunnel mode, tunnel source, or any other tunnel allow-remote address.
If you configure an allow-remote address, the tunnel source or tunnel mode commands fail if the outer
header address family does not match that of the configured allow-remote address.
tunnel destination
Set a destination endpoint for the tunnel.
Z9500
Syntax
tunnel destination {ip-address | ipv6–address}
To delete a tunnel destination address, use the no tunnel destination {ip-address | ipv6–
address} command.
Parameters
ip-address Enter the destination IPv4 address for the tunnel.
ipv6-address Enter the destination IPv6 address for the tunnel.
Defaults none
Command Modes INTERFACE TUNNEL (conf-if-tu)
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.5(0.1) Introduced on the Z9500.
9.2(0.2) Introduced on the Z9000, S4810, and S4820T.
Usage
Information
● The tunnel interface is inoperable without a valid reachable tunnel destination address of the
appropriate address type for the configured tunnel mode.
● The destination address establishes a logical tunnel to the specified destination address using a
destination address of the outer tunnel header. If you configure a tunnel interface or source address,
the tunnel destination must be compatible for this command to function.
1364 Tunneling Commands