Reference Guide

Usage
Information
Use the show util-threshold memory command to display the memory utilization thresholds used
to send SNMP traps. When Z9500 CPUs exceed the configured (high or low) memory percentage to
process packets or data, a threshold notification is sent as an SNMP trap. To reconfigure the currently
configured values, use the util-threshold memory command.
Example
Dell# show util-threshold memory
Processor High Low
================================
CP 92 82
RP 92 82
LP 0 92 82
LP 1 92 82
LP 2 92 82
Related
Commands
● util-threshold mem – Configure memory utilization thresholds.
● util-threshold cpu – Configure CPU utilization thresholds.
system location-led
Toggle the location LED of the chassis and (optionally) the location LED of a specified Z9500 port on or off.
Z9500
Syntax
system location-led [interface {fortyGigE | tengigabitethernet} slot/port]
{on | off}
Parameters
interface
{fortyGigE |
tengigabitethern
et}
Specify the port type: 40-Gigabit Ethernet or 10-Gigabit Ethernet.
slot / port Enter the slot and port number. The range of Z9500 slot numbers is 0 to 2.
on |off Turn the location LEDs of the chassis and a specified port on or off.
Defaults The location LEDs of the chassis and Z9500 ports are turned off.
Command Modes EXEC
Command
History
Version Description
9.2(1.0) Introduced on the Z9500.
8.2.1.0 Introduced on the E-Series ExaScale.
Usage
Information
Use the system location-led command to locate the chassis and (optionally) a port on the I/O side
of the Z9500 chassis. The location LED setting is not saved through power cycles.
telnet
Connect through Telnet to a server. The Telnet client and server in Dell Networking support IPv4 and IPv6 connections. You can
establish a Telnet session directly to the router or a connection can be initiated from the router.
NOTE:
The Telnet server and client are VRF-aware. Using the vrf parameter in this command, you can make a Telnet
server or client to listen to a specific VRF. This capability enables a Telent server or client to look up the correct routing
table and establish a connection.
Syntax
telnet {host | ip-address | ipv6-address prefix-length | vrf vrf instance
name } [/source-interface]
Control and Monitoring 135