Reference Guide

Parameters
packets_per_sec
ond in
Enter the packets per second of broadcast traffic allowed into the network. The
range is from 0 to 33554368.
Defaults none
Command Modes INTERFACE (conf-if-interface-slot/port)
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
7.4.1.0 E-Series Only: Added the percentage decimal value option.
6.5.1.0 Introduced on the E-Series.
storm-control multicast (Configuration)
Configure the packets per second (pps) of multicast traffic allowed into the C-Series and S-Series networks only.
Z9500
Syntax
storm-control multicast packets_per_second in
To disable storm-control for multicast traffic into the network, use the no storm-control
multicast packets_per_second in command.
Parameters
packets_per_sec
ond in
Enter the packets per second of multicast traffic allowed into the network. The
range is from 0 to 33554368.
Defaults none
Command Modes CONFIGURATION (conf)
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the C-series and S-Series.
Storm Control 1331