Reference Guide

show logging auditlog
Displays an audit log.
Syntax
show logging auditlog
Defaults none
Command Modes EXEC
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.5(0.1) Introduced on the Z9500.
9.5(0.0) Introduced on the S4810, S4820T, S6000, Z9000, and MXL.
Example
Dell(conf)#show logging audit
Related
Commands
clear logging auditlog — clears audit log.
show logging driverlog
Display the driver log for the specified hardware component.
Z9500
Syntax
show logging driverlog {cp | rp | linecard slot-id}
Parameters
cp Enter the keyword cp to display the driver log for the Control Processor on the
switch.
rp Enter the keyword cp to display the driver log for the Route Processor on the
switch.
linecard slot-id Enter the linecard slot-id parameters to specify the line-card ports for
which you want to display the driver log. The range of line-card slot IDs is from 0 to
2.
defaults none
Command Modes
● EXEC
● EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
Simple Network Management Protocol (SNMP) and Syslog 1319