Reference Guide

Version Description
7.8.1.0 Introduced on the S-Series.
7.6.1.0 Introduced on the C-Series.
6.2.1.1 Introduced on the E-Series.
Usage
Information
To enable the interface to send both version of RIP packets, use the ip rip send version 1 2
command.
Related
Commands
ip rip receive version — sets the RIP version for the interface to receive traffic.
version — sets the RIP version for the switch software.
ip split-horizon
Enable split-horizon for RIP data on the interface. As described in RFC 2453, the split-horizon scheme prevents any routes
learned over a specific interface to be sent back out that interface.
Z9500
Syntax
ip split-horizon
To disable split-horizon, use the no ip split-horizon command.
Defaults Enabled
Command Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.6.1.0 Introduced on the C-Series.
6.2.1.1 Introduced on the E-Series.
Related
Commands
ip poison-reverse — sets the prefix for RIP routing updates.
maximum-paths
Set RIP to forward packets over multiple paths.
Z9500
Syntax
maximum-paths number
To return to the default values, use the no maximum-paths commands.
Routing Information Protocol (RIP) 1163