Reference Guide

Example
Dell#conf
Dell(conf)#protocol spanning-tree pvst
Dell(conf-pvst)#no disable
Dell(conf-pvst)#vlan 2 bridge-priority 4096
Dell(conf-pvst)#vlan 3 bridge-priority 16384
Dell(conf-pvst)#
Dell(conf-pvst)#show config
!
protocol spanning-tree pvst
no disable
vlan 2 bridge-priority 4096
vlan 3 bridge-priority 16384
Dell#
Usage
Information
After you enable PVST+, the device runs an STP instance for each VLAN it supports.
Related
Commands
disable — disables PVST+.
show spanning-tree pvst — displays the PVST+ configuration.
show spanning-tree pvst
View the Per-VLAN spanning tree configuration.
Z9500
Syntax
show spanning-tree pvst [vlan vlan-id] [brief] [guard]
Parameters
vlan vlan-id (OPTIONAL) Enter the keyword vlan then the VLAN ID. The range is 1 to 4094.
brief (OPTIONAL) Enter the keyword brief to view a synopsis of the PVST+
configuration information.
interface (OPTIONAL) Enter one of the interface keywords along with the slot/port
information:
● For a Port Channel interface, enter the keyword port-channel then a
number: The range is 1 to 512.
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
guard (OPTIONAL) Enter the keyword guard to display the type of guard enabled on a
PVST interface and the current port state.
Defaults none
Command Modes
● EXEC
● EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
Per-VLAN Spanning Tree Plus (PVST+) 1099