Reference Guide

Version Description
8.3.7.1 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
7.5.1.0 Introduced on the E-Series.
Exmaple
Group Address / MaskLen
IPv6 PIM Commands
The following commands apply to IPv6 PIM-SM and IPv6 PIM-SSM.
● clear ipv6 pim tib
● debug ip pim
● ipv6 pim dr-priority
● ipv6 pim join-filter
● ipv6 pim query-interval
● ipv6 pim neighbor-filter
● show ipv6 pim interface
● show ipv6 pim neighbor
● show ipv6 pim tib
IPv6 PIM-Source Specific Mode Commands
The following IPv6 PIM-SSM commands are supported:
● ip pim ssm-range
● show ipv6 pim ssm-range
ipv6 pim ssm-range
Specify the SSM group range using an access list.
Z9500
Syntax
ipv6 pim ssm-range {access_list_name}
Parameters
access_list_name Enter the name of the access list. Maximum 16 characters.
Defaults Default SSM range is 232/8 and ff3x/32
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.5(0.1) Introduced on the Z9500.
PIM-Source Specific Mode (PIM-SSM) 1071