Reference Guide

PIM-Source Specific Mode (PIM-SSM)
The protocol-independent multicast source-specific mode (PIM-SSM) commands in this section are supported in the Dell
Networking operating system.
Topics:
• IPv4 PIM Commands
• IPv4 PIM-Source Specific Mode Commands
• ip pim ssm-range
• show ip pim ssm-range
• IPv6 PIM Commands
• IPv6 PIM-Source Specific Mode Commands
• ipv6 pim ssm-range
• show ipv6 pim ssm-range
IPv4 PIM Commands
The following commands apply to IPv4 PIM-SM, IPv4 PIM-SSM, and PIM-DM.
● clear ip pim tib
● debug ip pim
● ip pim dr-priority
● ip pim neighbor-filter
● ip pim query-interval
● show ip pim interface
● show ip pim neighbor
● show ip pim tib
IPv4 PIM-Source Specific Mode Commands
The following IPv4 PIM-source specific mode (PIM-SSM) commands are supported:
● ip pim ssm-range
● show ip pim ssm-range
ip pim ssm-range
Specify the SSM group range using an access list.
Syntax
ip pim [vrf vrf-name] ssm-range {access_list_name}
Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name of the VRF to specify
the SSM group range for that VRF.
NOTE: Applies to specific VRF if input is provided, else applies to Default VRF.
access_list_name Enter the name of the access list.
Defaults Default SSM range is 232/8 and ff3x/32
Command Modes CONFIGURATION
38
PIM-Source Specific Mode (PIM-SSM) 1069