Reference Guide

Version Description
7.4.1.0 Introduced
ipv6 pim bsr-candidate
Configure the router as a bootstrap (BSR) candidate.
Z9500
Syntax
ipv6 pim bsr-candidate interface [hash-mask-length] [priority]
To disable the bootstrap candidate, use the no ipv6 pim bsr-candidate command.
Parameters
interface Enter the following keywords and slot/port or number information:
● For a Loopback interface, enter the keyword loopback then a number from 0
to 16383.
● For a Port Channel interface, enter the keywords port-channel then a
number.
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
● For a VLAN, enter the keyword vlan then a number from 1 to 4094.
hash-mask-
length
(OPTIONAL) Enter the hash mask length for RP selection. The range is from 0 to
128. The default is 126.
priority (OPTIONAL) Enter the priority value for Bootstrap election process. The range is
from 0 to 255. The default is 0.
Defaults Refer to Parameters.
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.5(0.1) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
7.4.1.0 Introduced
ipv6 pim dr-priority
Change the designated router (DR) priority for the IPv6 interface.
Z9500
Syntax
ipv6 pim dr-priority priority-value
To remove the DR priority value assigned, use the no ipv6 pim dr-priority command.
1058 PIM-Sparse Mode (PIM-SM)