Reference Guide

PIM-Sparse Mode (PIM-SM)
The protocol-independent multicast sparse-mode (PIM-SM) commands in this section are supported in the Dell Networking
operating system.
Topics:
• IPv4 PIM-Sparse Mode Commands
• IPv6 PIM-Sparse Mode Commands
IPv4 PIM-Sparse Mode Commands
The following describes the IPv4 PIM-sparse mode (PIM-SM) commands.
clear ip pim rp-mapping
The bootstrap router (BSR) feature uses this command to remove all or particular rendezvous point (RP) advertisement.
Z9500
Syntax
clear ip pim [vrf vrf-name] rp-mapping [rp-address]
Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name of the VRF to configure
this setting on that VRF.
NOTE: Applies to specific VRF if input is provided, else applies to Default VRF.
rp-address (OPTIONAL) Enter the RP address in dotted decimal format (A.B.C.D).
Command Modes EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Added support for VRF. Introduced on the S6000-ON.
9.5(0.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.8.1.0 Introduced on the S-Series.
Usage
Information
This command re-applies the RP mapping logic for all the groups learnt by the node. Any stale information
corresponding to the existing mapping configuration is updated. As a result, the existing BSR cache and
the *,G's are deleted only if these entries are stale.
37
PIM-Sparse Mode (PIM-SM) 1033