Reference Guide

show crypto ipsec sa ipv6
Display the IPsec security associations (SAs) used on OSPFv3 interfaces.
Z9500
Syntax
show crypto ipsec sa ipv6 [interface interface]
Parameters
interface
interface
(OPTIONAL) Displays information about the SAs used on a specified OSPFv3
interface, where interface is one of the following values:
● For a Port Channel interface, enter port-channel number.
● For a 10-Gigabit Ethernet interface, enter TenGigabitEthernet slot/
port.
● For a 40–Gigabit Ethernet interface, enter fortyGigE slot/port.
● For a VLAN interface, enter vlan vlan-id. The valid VLAN IDs range is from
1 to 4094.
Defaults No default behavior or values.
Command Modes
EXEC
EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
9.1.(0.0) Introduced on the S4810 and Z9000.
8.4.2.0 Introduced on the E-Series TeraScale.
8.3.19.0 Introduced on the S4820T.
Usage
Information
The show crypto ipsec sa ipv6 command output displays security associations set up for
OSPFv3 links in IPsec authentication and encryption policies on the router.
Related
Commands
show crypto ipsec policy – displays the configuration of IPsec authentication and encryption policies.
Example
Dell#show crypto ipsec policy
Dell#show crypto ipsec sa ipv6
Interface: TenGigabitEthernet 0/0
Link Local address: fe80::201:e8ff:fe40:4d10
IPSecv6 policy name: OSPFv3-1-500
inbound ah sas
spi : 500 (0x1f4)
transform : ah-md5-hmac
in use settings : {Transport, }
replay detection support : N
STATUS : ACTIVE
outbound ah sas
spi : 500 (0x1f4)
transform : ah-md5-hmac
in use settings : {Transport, }
replay detection support : N
STATUS : ACTIVE
1024 Open Shortest Path First (OSPFv2 and OSPFv3)