Command Line Reference Guide

lacp system-priority
Configure the LACP system priority.
Z9500
Syntax
lacp system-priority priority-value
Parameters
priority-value Enter the port-priority value. The higher the value number,
the lower the priority. The range is from 1 to 65535. The
default is 32768.
Defaults 32768
Command
Modes
INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.2.1.1 Introduced on the E-Series.
port-channel mode
Configure the LACP port channel mode.
Z9500
Syntax
port-channel number mode [active] [passive] [off]
Parameters
number Enter the keywords number then a number.
active Enter the keyword active to set the mode to the active
state.
Link Aggregation Control Protocol (LACP)
995