Command Line Reference Guide

Leaves ---- 0
MLDv2 Queries 18000 ----
MLDv1 Queries 0 ----
Errors:
Malformed Packets: 4510
show ipv6 neighbors
Display information about the IPv6 neighbors learned on Z9500 CPUs.
Z9500
Syntax
show ipv6 neighbors [cpu rp] [ipv6–address] {ipv6–address}]
[interface interface]
Parameters
cpu rp Enter the keywords cpu rp to display information about
IPv6 neighbors learned only on the Route Processor.
ipv6–address Enter the IPv6 address of a neighbor to display information
about the specified device.
interface Enter one of the following keywords with slot/port or
number to display information about the IPv6 neighbors
learned on the specified port, port channel, or VLAN:
• For a 10-Gigabit Ethernet interface, enter the keyword
tengigabitethernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a port-channel interface, enter the keyword port-
channel with a port-channel number. The range of
port-channel numbers is from 1 to 128.
• For VLAN interfaces, enter the keyword vlan with a VLAN
ID from 1 to 4094.
Defaults Display information about IPv6 neighbors learned on all Z9500 CPUs, including the
Route Processor and line-card processors.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
916
IPv6 Basics