Command Line Reference Guide

Version Description
9.2(0.0) Added support for the fcoe parameter on the S4810 and
S4820T.
9.1.(0.0) Added support for OpenFlow on the Z9000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Added the keywords fcoeacl and iscsioptacl on the
S4810.
8.3.11.1 Introduced on the Z9000.
8.3.1.0 Added the keywords ecfmacl, vman-qos, and vman-
dual-qos.
8.2.1.0 Introduced on the S-Series.
7.8.1.0 Introduced on the C-Series.
Usage
Information
For the new settings to take effect, save the new CAM settings to the startup-
config (write-mem or copy run start) then reload the system.
The total amount of space allowed is 16 FP Blocks. System flow requires three
blocks and these blocks cannot be reallocated. The
ipv4acl profile range is from
1 to 4.
When configuring space for IPv6 ACLs, the total number of Blocks must equal 13.
Ranges for the CAM profiles are from 1 to 10, except for the ipv6acl profile which
is from 0 to 10. The
ipv6acl allocation must be a factor of 2 (2, 4, 6, 8, 10).
If you enabled BMP 3.0, to perform a reload on the chassis to upgrade any
configuration changes that have changed the NVRAM content, use the reload
conditional nvram-cfg-change command.
cam-audit linecard
Enable audit of the IPv4 forwarding table on all line cards.
Z9500
Syntax
cam-audit linecard all ipv4-fib interval time-in-minutes
Parameters
all Enter the keyword all to enable CAM audit on all line cards.
ipv4-fib Enter the keyword ipv4-fib to designate the CAM audit on
the IPv4 forwarding entries.
Control and Monitoring
89