Command Line Reference Guide

cam-acl
Allocate content addressable memory (CAM) for IPv4 and IPv6 ACLs.
Z9500
Syntax cam-acl {default | l2acl number ipv4acl number ipv6acl number ipv4qos number
l2qos number l2pt number ipmacacl number [vman-qos | vman-dual-qos] number
ecfmacl number {openflow {4|8}}
Parameters
default Use the default CAM profile settings and set the CAM as
follows:
• L3 ACL (ipv4acl): 4
• L2 ACL(l2acl): 6
• IPv6 L3 ACL (ipv6acl): 0
• L3 QoS (ipv4qos): 2
• L2 QoS (l2qos): 1
• OpenFlow: 0 (disabled)
• FCoE (fcoeacl): 0 (disabled)
• iSCSI Optimization (iscsioptacl): 0 (disabled)
l2acl number
ipv4acl number
ipv6acl number
ipv4qos
number l2qos
number l2pt
number
ipmacacl
number [vman-
qos | vman-
dual-qos]
number
ecfmacl
number
{openflow {4|
8}}
Allocate space to each CAM region.
Enter the CAM profile name then the amount of CAM space
to be allotted. The total space allocated must equal 13. The
ipv6acl range must be a factor of 2.
Enter 4 or 8 for the number of OpenFlow FP blocks.
• 4: Creates 242 entries for use by the OpenFlow controller
(256 total entries minus the 14 entries reserved for
internal functionality)
• 8: Creates 498 entries for use by the OpenFlow controller
(512 total entries minus the 14 entries reserved for
internal functionality)
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
88
Control and Monitoring