Command Line Reference Guide

TenGigabitEthernet 0/2 unassigned NO Manual
administratively down down
TenGigabitEthernet 0/3 unassigned NO Manual
administratively down down
fortyGigE 0/4 unassigned NO Manual
administratively down down
fortyGigE 0/8 unassigned NO Manual
administratively down down
--More--
Dell# show ip interface configured
TenGigabitEthernet 0/0 is down, line protocol is down
Internet address is not set
IP MTU is 1500 bytes
Directed broadcast forwarding is disabled
Proxy ARP is enabled
Split Horizon is enabled
Poison Reverse is disabled
ICMP redirects are not sent
ICMP unreachables are not sent
TenGigabitEthernet 0/1 is down, line protocol is down
Internet address is 10.10.10.1/24
Broadcast address is 10.10.10.255
Address determined by config file
IP MTU is 1500 bytes
Directed broadcast forwarding is disabled
Proxy ARP is enabled
Split Horizon is enabled
Poison Reverse is disabled
ICMP redirects are not sent
ICMP unreachables are not sent
--More--
Usage
Information
The following describes the show ip interface brief command shown in the
following example.
Fields Description
Interface Displays type of interface and the associated slot and port
number.
IP-Address Displays the IP address for the interface, if configured.
Ok? Indicates if the hardware is functioning properly.
Method Displays “Manual” if the configuration is read from the saved
configuration.
Status States whether the interface is enabled (up) or disabled
(administratively down).
Protocol States whether IP is enabled (up) or disabled (down) on the
interface.
Example (Brief)
Dell#show ip int brief
Interface IP-Address OK? Method
Status Protocol
TenGigabitEthernet 1/0 unassigned NO Manual
administratively down down
TenGigabitEthernet 1/1 unassigned NO Manual
administratively down down
IPv4 Routing
851