Command Line Reference Guide

linecard slot-id Enter the linecard slot-id parameters to specify the
Z9500 ports on a line card. The range of slot IDs is from 0 to
2.
brief (OPTIONAL) Enter the keyword brief to view a brief
summary of the interfaces and whether an IP address is
assigned.
configured (OPTIONAL) Enter the keyword configured to display the
physical interfaces with non-default configurations only.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
8.3.7.0 Introduced on the S4810.
8.1.1.2 Supported on the E-Series ExaScale E600i.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.0 Introduced on the E-Series.
Usage
Information
The following describes the show ip interface command shown in the
following example.
Lines Description
TenGigabitEthern
et 0/0...
Displays the interface’s type, slot/port, and physical and line
protocol status.
Internet address... States whether an IP address is assigned to the interface. If
an IP address is assigned, that address is displayed.
IP MTU is... Displays IP MTU value.
Inbound access... Displays the name of the configured incoming access list. If
none is configured, the phrase “not set” is displayed.
IPv4 Routing
849