Command Line Reference Guide

Parameters
interface
interface
Enter the keyword interface then one of the following
interface keywords.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
source-ip
address
Enter the keywords source-ip then the IP source address
in IP address format.
destination-ip
address
Enter the keywords destination-ip then the IP
destination address in IP address format.
protocol
number [tcp |
udp]
Enter the keyword protocol then one of the protocol type
keywords: tcp, udp, or protocol number The protocol
number range is from 0 to 255. .
src-port
number
Enter the keywords src-port then the source port number.
destination-
port number
Enter the keywords destination-port then the destination
port number.
Command
Modes
EXEC
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.10.0 Introduced on the S4810.
8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
8.1.1.0 Introduced on the E-Series ExaScale.
7.9.1.0 Introduced VRF on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.0 Introduced on the E-Series.
Usage
Information
This command provides egress port information for a given IP flow. This
information is useful in identifying which interface the packet follows in the case of
IPv4 Routing
847