Command Line Reference Guide

show ip cam linecard
View CAM entries for a port pipe on a line card.
Z9500
Syntax
show ip cam linecard slot-id port-set pipe-number [ip-address
mask [longer-prefix] | ecmp-group [details | member-info] |
summary]
Parameters
slot-id Enter the slot ID of the line card. The range of Z9500 slot IDs
is from 0 to 2.
pipe-number Enter the number of a line card’s port-pipe. The range is
from 0 to 3.
ip-address
mask [longer-
prefix]
(OPTIONAL) Enter the IP address and mask of a route to
CAM entries for that route only. Enter the keyword longer-
prefixes to view routes with a common prefix.
ecmp-group
{details |
member-info}
(OPTIONAL) Enter the keyword ecmp-group and specify if
you want to display detailed CAM information about an
ECMP group or about individual ECMP-group member ports.
summary (OPTIONAL) Enter the keyword summary to view a table
listing route prefixes and the total number of routes that can
be entered into the CAM.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.7.0 Introduced on the S4810.
8.1.1.2 Introduced on the E-Series ExaScale E600i.
8.1.1.0 Introduced on the E-Series ExaScale.
7.9.1.0 Introduced VRF on the E-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.0 Introduced on the E-Series.
842
IPv4 Routing