Command Line Reference Guide

Version Description
6.1.1.0 Introduced on the E-Series.
Usage
Information
When a static route (or a protocol route) overlaps with Management static route,
the static route (or a protocol route) is preferred over the Management Static route.
Also, Management static routes and the Management Connected prefix are not
reflected in the hardware routing tables. Separate routing tables are maintained for
IPv4 and IPv6 management routes. This command manages both tables.
Related
Commands
interface ManagementEthernet — configures the Management port on the system
(either the Primary or Standby RPM).
duplex (Management) — sets the mode of the Management interface.
speed (Management interface) — sets the speed for the Management interface.
show arp
Display the ARP entries learned on a Z9500 CPU.
Z9500
Syntax
show arp [cpu [cp | rp]] [interface interface | ip ip-address
[mask] | macaddress mac-address mask] [static | dynamic]
[summary]
Parameters
cpu cp (OPTIONAL) Enter the keywords cpu cp to display the ARP
entries learned on the Control Processor.
cpu rp (OPTIONAL) Enter the keyword cpu rp to display the ARP
entries learned on the Route Processor.
interface
interface
To specify an interface, enter one of the following interface
types and slot/port or number information:
• For Loopback interfaces, enter the keyword loopback
then a number from zero (0) to 16383.
• For a Port Channel interface, enter the keyword port-
channel
then a number. The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a VLAN interface, enter the keyword vlan then a
number from 1 to 4094.
• For a tunnel interface, enter the keyword tunnel.
836
IPv4 Routing