Command Line Reference Guide

• When recursive resolution is “broken,” the system withdraws the route.
• When recursive resolution is satisfied, the system re-installs the route.
Related
Commands
show ip route — views the switch routing table.
show ipv6 route — displays the IPv6 routes.
ip source-route
Enable the system to forward IP packets with source route information in the header.
Z9500
Syntax
ip source-route
To drop packets with source route information, use the no ip route-source
command.
Defaults Enabled.
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.0 Introduced on the E-Series.
IPv4 Routing
829