Command Line Reference Guide

Version Description
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.0 Introduced on the E-Series.
Related
Commands
show ip interface — displays the interface routing status and configuration.
ip route
Assign a static route to the switch.
Z9500
Syntax
ip route {destination mask {ip-address | interface [slot/port]
| [tunnel tunnel-id] [distance] | [permanent] | tag tag-value}}
To delete a specific static route, use the no ip route destination mask
command.
To delete all routes matching a certain route, use the no ip route
destination mask command.
Parameters
destination Enter the IP address in dotted decimal format of the
destination device.
mask Enter the mask in the slash prefix format (/x) of the
destination IP address.
ip-address Enter the IP address of the forwarding router in dotted
decimal format.
interface slot/
port
Enter the keyword interface then the slot/port number.
tunnel tunnel-
id
Enter the keyword tunnel then the tunnel ID.
distance (OPTIONAL) Enter the value of the distance metric assigned
to the route. The range is from 1 to 255.
IPv4 Routing
827