Command Line Reference Guide

ip domain-name
Configure one domain name for the switch.
Z9500
Syntax
ip domain-name name
To remove the domain name, use the no ip domain-name command.
Parameters
name Enter one domain name to be used to complete unqualified
names (that is, incomplete domain names that cannot be
resolved).
Defaults Not configured.
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
Usage
Information
You can only configure one domain name with the ip domain-name command.
To configure more than one domain name, configure the ip domain-list
command up to six times.
To enable dynamic resolution of hosts, use the following steps:
• specify a domain name server with the ip name-server command
• enable DNS with the ip domain-lookup command
To view current bindings, use the show hosts command.
Related
Commands
ip domain-list — configures additional names.
IPv4 Routing
819