Command Line Reference Guide

turned off
Dell#
ip address
Assign a primary and secondary IP address to the interface.
Z9500
Syntax
ip address {ip-address mask [secondary] | dhcp}
To delete an IP address from an interface, use the no ip address [ip-
address
] command.
Parameters
ip-address Enter an IP address in dotted decimal format.
mask Enter the mask of the IP address in slash prefix format (for
example, /24).
secondary (OPTIONAL) Enter the keyword secondary to designate the
IP address as the secondary address.
dhcp Enter the keyword dhcp to configure an interface to receive
its IP address from the configured DHCP server.
Defaults Not configured.
Command
Modes
INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
IPv4 Routing
815