Command Line Reference Guide

Command
History
Version Description
9.2.1.0 Introduced on the Z9500 switch.
9.3.0.0 Introduced on the Z9000 platform.
UDP Broadcast
The user datagram protocol (UDP) broadcast feature is a software-based method to forward low
throughput (not to exceed 200 pps) IP/UDP broadcast traffic arriving on a physical or VLAN interface.
Important Points to Remember
• Routing information protocol (RIP) is not supported with the UDP Broadcast feature.
• If you configure this feature on an interface using the ip udp-helper udp-port command, the ip
directed-broadcast command becomes ineffective on that interface.
• The existing show interface command has been modified to display the configured broadcast
address.
debug ip udp-helper
Enable UDP debug and display the debug information on a console.
Z9500
Syntax
debug ip udp-helper
To disable debug information, use the no debug ip udp-helper command.
Defaults Debug disabled.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.3.7.0 Introduced on the E-Series ExaScale.
Interfaces
785