Command Line Reference Guide

Usage
Information
The trigger-threshold of bandwidth usage, which determines when the calculation
of link-bundle utilization is performed, is set at 60 percent of the link-bundle
bandwidth. When the total traffic use (mean) is below the trigger-threshold
percentage, unevenness in link-bundle traffic distribution is not reported. If traffic
unevenness is detected in three consecutive measurements, an alarm is issued. The
time interval between measurements is defined by the rate interval for HiGig link
polling (default 15 seconds).
show hardware hg-stats
Display the traffic statistics from internal ports in a HiGig link bundle/port channel on a line-card or
switch fabric module (SFM) NPU.
Z9500
Syntax
show hardware {sfm npu-id | linecard slot} hg-stats {port hg-
port—number | unit npu-id port hg-port—number}
Parameters
sfm npu-id Specify a Z9500 SFM (spine) NPU by entering the keyword
sfm and SFM NPU ID. Valid SFM NPU IDs are 0 to 5.
linecard slot Specify a Z9500 line-card (leaf) NPU by entering the
keyword linecard and line-card slot. Valid slot numbers
are 0 to 2.
hg-stats {port
hg-port-
number | unit
npu-id port hg-
port-number}
Enter the keyword hg-stats to display HiGig port statistics.
For an SFM NPU HiGig link bundle, specify only a HiGig port
number. Valid SFM hg-port-number values are 1 to 22.
For a line-card NPU HiGig link bundle, specify an NPU ID and
a HiGig port number. Line-card NPUs range from 0 to 3.
Line-card HiGig port numbers range from 50 to 61.
Defaults none
Command
Modes
• EXEC
• EXEC Privilege
Command
History
Version Description
9.2.1.0 Introduced on the Z9500 switch.
9.3.0.0 Added support for the hg-stats option on the Z9000
platform.
Example (Line-
card HiGig
Port)
Dell# show hardware linecard 0 hg-stats unit 0 port 59
Higig Port Statistics:
HiGigabitEthernet 0/0/59,
Input Statistics:
0 packets, 0 bytes
0 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts
0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-
Interfaces
781