Command Line Reference Guide

U 1
Name: Port-channel 23
802.1QTagged: False
Vlan membership:
Q Vlans
U 1
Dell# show interfaces switchport tengigabitethernet 2
Codes: U - Untagged, T - Tagged
x - Dot1x untagged, X - Dot1x tagged
G - GVRP tagged, M - Trunk
i - Internal untagged, I - Internal tagged, v - VLT
untagged, V - VLT tagged
Name: TenGigabitEthernet 2/0
802.1QTagged: False
Vlan membership:
Q Vlans
U 1
Name: TenGigabitEthernet 2/1
802.1QTagged: False
Vlan membership:
Q Vlans
U 1
Related
Commands
interface — configures a physical interface on the switch.
show ip interface — displays Layer 3 information about the interfaces.
show interfaces — displays information on a specific physical interface or virtual
interface.
show interfaces transceiver — displays the physical status and operational status of
an installed transceiver. The output also displays the transceiver’s serial number.
show interfaces transceiver
Display the physical status and operational status of an installed transceiver. The output also displays the
transceiver’s serial number.
Z9500
Syntax
show interfaces [tengigabitethernet slot/port | fortyGigE slot/
port] transceiver
Parameters
tengigabitether
net
For a 10G interface, enter the keyword
tengigabitethernet then the slot/port information.
fortyGigE For a 40G interface, enter the keyword fortyGigE then the
slot/port information.
Command
Modes
• EXEC
750
Interfaces