Command Line Reference Guide

• 100MB
• 10MB
Example
Dell#show int tengigabitethernet 1/0 phy
Mode Control:
SpeedSelection: 10b
AutoNeg: ON
Loopback: False
PowerDown: False
Isolate: False
DuplexMode: Full
Mode Status:
AutoNegComplete: False
RemoteFault: False
LinkStatus: False
JabberDetect: False
AutoNegotation Advertise:
100MegFullDplx: True
100MegHalfDplx: True
10MegFullDplx: False
10MegHalfDplx: True
Asym Pause: False
Sym Pause: False
AutoNegotiation Remote Partner's Ability:
100MegFullDplx: False
100MegHalfDplx: False
10MegFullDplx: False
10MegHalfDplx: False
Asym Pause: False
Sym Pause: False
AutoNegotiation Expansion:
ParallelDetectionFault: False
...
Related
Commands
show interfaces — displays information on a specific physical interface or virtual
interface.
show interfaces status
To display status information on a specific interface only, display a summary of interface information or
specify a line card slot and interface.
Z9500
Syntax
show interfaces [interface | linecard slot-number] status
Parameters
interface (OPTIONAL) Enter one of the following keywords and slot/
port or number information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a Loopback interface, enter the keyword loopback
then the slot/port information. The range is from 0 to
16383.
746
Interfaces