Command Line Reference Guide

LineSpeed 10000 Mbit
Flowcontrol rx on tx off
ARP type: ARPA, ARP Timeout 04:00:00
Last clearing of "show interface" counters 01:47:42
Queueing strategy: fifo
Input Statistics:
0 packets, 0 bytes
0 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts
0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-
byte pkts
0 Multicasts, 0 Broadcasts
0 runts, 0 giants, 0 throttles
0 CRC, 0 overrun, 0 discarded
Output Statistics:
0 packets, 0 bytes, 0 underruns
0 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts
0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-
byte pkts
0 Multicasts, 0 Broadcasts, 0 Unicasts
0 throttles, 0 discarded, 0 collisions, 0 wreddrops
Rate info (interval 299 seconds):
Input 00.00 Mbits/sec, 0 packets/sec, 0.00% of
line-rate
Output 00.00 Mbits/sec, 0 packets/sec, 0.00% of
line-rate
Time since last interface status change: 01:46:17
TenGigabitEthernet 2/2 is down, line protocol is down
Hardware is DellForce10Eth, address is 74:86:7a:ff:6f:18
Current address is 74:86:7a:ff:6f:18
Pluggable media present, Media type is unknown
Wavelength is 0.00nm
--More--
Related
Commands
show interfaces — displays information on a specific physical interface or virtual
interface.
show interfaces dampening
Display interface dampening information.
Z9500
Syntax
show interfaces dampening [[interface] [linecard slot-id]
[summary] [detail]]
Parameters
interface (Optional) Enter one of the following keywords and slot/port
or number information:
• For a Port Channel interface, enter the keywords port-
channel then a number. The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
742
Interfaces