Command Line Reference Guide

ManualsBrandsDell ManualsComputer equipmentNetworking Z9500

741

742

743

744

745

746

747

748

749

750

Command

History

Version Description

9.2(1.0) Introduced on the Z9500.

8.3.19.0 Introduced on the S4820T.

8.3.11.1 Introduced on the Z9000.

8.3.7.0 Introduced on the S4810.

8.1.1.0 Introduced on the E-Series ExaScale.

7.6.1.0 Introduced on the S-Series.

7.5.1.0 Introduced on the C-Series.

6.4.1.0 Changed the organization of the display output.

Example

Dell# show interfaces configured

TenGigabitEthernet 2/0 is down, line protocol is down

Hardware is DellForce10Eth, address is 74:86:7a:ff:6f:18

Current address is 74:86:7a:ff:6f:18

Pluggable media present, Media type is unknown

Wavelength is 0.00nm

Interface index is 151060994

Internet address is not set

MTU 1554 bytes, IP MTU 1500 bytes

LineSpeed 10000 Mbit

Flowcontrol rx on tx off

ARP type: ARPA, ARP Timeout 04:00:00

Last clearing of "show interface" counters 01:47:42

Queueing strategy: fifo

Input Statistics:

0 packets, 0 bytes

0 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts

0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-

byte pkts

0 Multicasts, 0 Broadcasts

0 runts, 0 giants, 0 throttles

0 CRC, 0 overrun, 0 discarded

Output Statistics:

0 packets, 0 bytes, 0 underruns

0 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts

0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-

byte pkts

0 Multicasts, 0 Broadcasts, 0 Unicasts

0 throttles, 0 discarded, 0 collisions, 0 wreddrops

Rate info (interval 299 seconds):

Input 00.00 Mbits/sec, 0 packets/sec, 0.00% of

line-rate

Output 00.00 Mbits/sec, 0 packets/sec, 0.00% of

line-rate

Time since last interface status change: 01:46:17

TenGigabitEthernet 2/1 is down, line protocol is down