Command Line Reference Guide

Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.0 Introduced on the E-Series.
Example
Dell(conf)#interface range tengigabitethernet 1/1 - 2
Dell(conf-if-range-te-1/1-2)#show config
!
interface TenGigabitEthernet 1/1
no ip address
switchport
no shutdown
!
interface TenGigabitEthernet 1/2
no ip address
switchport
no shutdown
Dell(conf-if-range-te-1/1-2)#
show interfaces
Display information on a specific physical interface or virtual interface, or the interfaces of the same type
on a line card.
Z9500
Syntax
show interfaces [interface] [linecard slot-id]
Parameters
interface Enter one of the following keywords and slot/port or number
information:
• For a Loopback interface, enter the keyword loopback
followed by a number from 0 to 16383.
• For a Null interface, enter the keywords null 0.
• For a Port Channel interface, enter the keywords port-
channel then a number. The range is 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
Interfaces
733