Command Line Reference Guide

reset linecard
Reset the ports on a Z9500 line card.
Z9500
Syntax
reset linecard slot-id
Parameters
linecard slot-id Enter the slot ID number to specify the set of line-card ports
to be reset. The range of Z9500 line-card slot IDs is 0 to 2.
Defaults none
Command
Modes
EXEC
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell NetworkingOS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.7.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
8.3.1.0 Added the hard reset option.
7.8.1.0 Augmented to run on the standby unit in order to reset the
standby unit directly.
7.7.1.0 Introduced on the S-Series.
Usage
Information
Resetting is a soft reboot, including flushing the forwarding tables.
Example
Stack MAC : 00:01:e8:8b:1a:36
Reload-Type : normal-reload [Next boot : normal-reload]
-- Stack Info --
Unit UnitType Status ReqTyp CurTyp Version Ports
----------------------------------------------------
0 Management online S4810 S4810 8-3-12-1 64
1 Standby online S4810 S4810 8-3-12-1 64
2 Member online S4810 S4810 8-3-12-1 64
3 Member online S4810 S4810 8-3-12-1 64
4 Member online S4810 S4810 8-3-12-1 64
5 Member online S4810 S4810 8-3-12-1 64
6 Member not present
7 Member not present
8 Member not present
9 Member not present
10 Member not present
11 Member not present
Interfaces
731