Command Line Reference Guide

pps 0
Over 127B packets: 0 0
pps 0
Over 255B packets: 0 0
pps 0
Over 511B packets: 0 0
pps 0
Over 1023B packets: 0 0
pps 0
Error statistics:
00:04:36: %RPM0-P:CP %CHMGR-5-PEM_INSERTED: Power entry module
3 of unit 0 is inserted
Input underruns: 0 0
pps 0
Input giants: 0 0
pps 0
00:04:36: %RPM0-P:CP %CHMGR-0-PS_UP: Power supply 3 in unit 0
is up
Input throttles: 0 0
pps 0
Input CRC: 0 0
pps 0
Input IP checksum: 0 0
pps 0
Input overrun: 0 0
pps 0
Output underruns: 0 0
pps 0
Output throttles: 0 0
pps 0
m - Change mode c - Clear
screen
l - Page up a - Page down
T - Increase refresh interval t - Decrease
refresh interval
q - Quit
mtu
Set the link maximum transmission unit (MTU) (frame size) for an Ethernet interface.
Z9500
Syntax
mtu value
To return to the default MTU value, use the no mtu command.
Parameters
value Enter a maximum frame size in bytes. The range is from 592
to 9216. The default is 9216.
Defaults 9216
Command
Modes
INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
726
Interfaces