Command Line Reference Guide

Version Description
9.2(1.0) Introduced on the Z9500.
Usage
Information
Enabling quad mode on a port removes the interface configurations (if any) on the
port after a save and reload. Be sure that the port is removed from other L2 and L3
feature configurations.
You must save and reload the system for the 40G to 4x10G port change to take
effect.
This command cannot be used if LR4 optics are inserted in the 40G port.
monitor interface
Monitor counters on a single interface or all interfaces on a line card. The screen is refreshed every five
seconds and the CLI prompt disappears.
Z9500
Syntax
monitor interface [interface] [linecard slot-id]
To disable monitoring and return to the CLI prompt, press the q key.
Parameters
interface (OPTIONAL) Enter the following keywords and slot/port or
number information:
• For the management port, enter the keyword
managementethernet then the slot (0 or 1) and the port
(0).
• For a Tunnel interface, enter the keyword tunnel then
the slot/port. The range is from 1 to 16383.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a VLAN interface, enter the keyword vlan then the
slot/port. The range is from 1 to 4094.
linecard slot-id Enter the linecard slot-id parameters to specify the
Z9500 ports on a line card. The range of slot IDs is from 0 to
2.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
722
Interfaces