Command Line Reference Guide

no shut on the interface, then check the running-config of the port using the
show interface command.
Important Points to Remember
• Do not enable tx pause when buffer carving is enabled. For information and
assistance, consult Dell Networking TAC.
• Asymmetric flow control (rx on tx off, or rx off tx on) setting for the
interface port less than 100 Mb/s speed is not permitted. The following error is
returned:
Can’t configure Asymmetric flowcontrol when speed <1G,
config ignored
• The only configuration applicable to half duplex ports is rx off tx off. The
following error is returned:
Can’t configure flowcontrol when half duplex is configure,
config ignored
• Half duplex cannot be configured when the flow control configuration is on
(default is rx on tx on). The following error is returned:
Can’t configure half duplex when flowcontrol is on, config
ignored
NOTE: The flow control must be off (rx off tx off) before configuring the
half duplex.
NOTE: If you use the disable rx flow control command, Dell
Networking recommends rebooting the system.
Example
Dell(conf-if-te-0/1)#show config
!
interface TengigabitEthernet 0/1
no ip address
switchport
no negotiation auto
flowcontrol rx off tx on
no shutdown
...
Related
Commands
show running-config — displays the flow configuration parameters (non-default
values only).
show interfaces — displays the negotiated flow control parameters.
interface
Configure a physical interface on the switch.
Z9500
Syntax
interface interface range
Parameters
interface Enter one of the following keywords and slot/port or number
information:
Interfaces
709