Command Line Reference Guide

Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
8.3.11.1 Introduced on the Z9000.
8.1.1.0 Introduced on the E-Series ExaScale.
7.5.1.0 Introduced on the C-Series.
7.4.1.0 Documentation modified—added Management to
distinguish from duplex (10/100 Interfaces).
Usage
Information
This command applies only to the Management interface on the route processor
modules (RPMs).
Related
Commands
interface ManagementEthernet — configures the Management port on the system
(either the Primary or Standby RPM).
duplex (Management) — sets the mode of the Management interface.
management route — configures a static route that points to the Management
interface or a forwarding router.
speed (Management interface) — sets the speed on the Management interface.
flowcontrol
Enable and disable link-level flow control (802.3x pause frames) on an interface and (optionally)
configure buffer thresholds for pause and offset frame transmission.
Z9500
Syntax
flowcontrol rx {off | on} tx {off | on} [pause-threshold
{1-12480}] [resume-offset {1-12480}]
Parameters
rx on Enter the keywords rx on to process the received flow
control frames on this port.
rx off Enter the keywords rx off to ignore the received flow
control frames on this port.
tx on Enter the keywords tx on to send control frames from the
port to the connected device when a higher rate of traffic is
received.
tx off Enter the keywords tx off so that flow control frames are
not sent from this port to the connected device when a
higher rate of traffic is received.
Interfaces
707